iMac (24-inch, 2024, Two ports)

Begin with standard prep before any hardware work: confirm the Mac model, protect data, isolate power, and document the original layout. This reduces screw mix-ups, prevents accidental shorts, and makes later component replacement safer and faster.

This procedure involves separating the display assembly from the Mac chassis for service or replacement. Technicians must disconnect all display-related cables, support the panel properly, and manage hinge hardware to prevent damage to the display or case.

This procedure restores the display assembly after service, including cables, shields, adhesives, and mounting hardware. Successful reassembly depends on precise cable routing, even pressure, and thorough checks before the machine is fully closed.

This procedure replaces the Mac's stand assembly, usually on desktop models. Technicians generally stabilize the unit, remove stand fasteners or locking hardware, and fit the replacement so the display or chassis remains properly balanced.

This procedure covers installation or replacement of a VESA mount adapter on an iMac or similar display-equipped Mac. It focuses on removing the existing stand interface, transferring hardware as required, and securing the adapter without stressing the display housing.

This procedure replaces the EMI shield that sits over the logic board to reduce interference and protect sensitive circuits. Proper seating is important because a loose shield can cause noise, fit issues, or contact problems.

This repair covers a single USB-C board used for power, data, or auxiliary connectivity depending on the Mac model. The procedure typically involves disconnecting the board cables, removing mounting hardware, and transferring shields or brackets as needed.

This procedure covers removing and replacing a small adapter board that links two internal assemblies or converts one connector style to another. The job usually involves careful cable handling, tight access, and verifying that each connector is seated and oriented correctly.

This procedure involves replacing the internal audio board that manages headphone, microphone, or speaker-related connections on some Mac models. The work usually includes disconnecting several small cables, removing a compact board, and verifying clean audio output after installation.

This procedure covers removing and replacing a single cooling fan in the Mac. A properly installed fan is essential for thermal management, so technicians should inspect the fan blade path, connector, and dust buildup during service.

This procedure covers a combined antenna assembly used for both Wi-Fi and Bluetooth communication. Because the functions share closely routed coax lines or a shared antenna module, clean routing and correct connector pairing are essential for reliable wireless and peripheral performance.

This procedure covers replacement or reseating of a single Wi-Fi antenna in a Mac. The work usually involves delicate coax cable handling, correct routing through the chassis, and secure connector placement to restore stable wireless reception.

This procedure covers removing and replacing the combined camera and embedded DisplayPort flex cable that links the display assembly to the logic board. Technicians must handle the thin cable carefully to avoid tearing connectors or damaging nearby display components.

This procedure addresses replacing the flex cable that supplies backlight power or control to the display. Because a backlight failure can mimic a dead screen, technicians should inspect the cable, connectors, and adjacent components carefully before reassembly.

A high-speed flex cable carries sensitive data or display signals, so replacement depends on precise routing and careful connector handling. Any sharp bend, twist, or pinched section can cause intermittent failures that are hard to diagnose later.

This procedure replaces the main logic board, which controls power distribution, storage access, and most system functions. It is a major repair that requires careful cable management, thorough screw tracking, and post-installation testing.

This procedure replaces the low-speed flex cable that carries signaling for accessory, sensor, or control functions. Because these cables are thin and folded into tight spaces, damage often comes from pinching, tearing, or poor routing.

This procedure covers removing and replacing the internal battery pack. The work usually includes disconnecting power, softening adhesive, and lifting out the battery safely without stressing the cells or nearby logic board components.

Housing replacement is a major enclosure-level repair that transfers the internal assemblies into a new shell. It requires complete disassembly, careful part migration, and close attention to grounding points, screw lengths, and alignment so the finished system closes correctly.